From:	SMTP%"RELAY-INFO-VAX@CRVAX.SRI.COM"  6-JUL-1993 09:12:25.34
To:	EVERHART
CC:	
Subj:	Re: How to set RZ24 SCSI address?

X-Newsgroups: comp.os.vms
Subject: Re: How to set RZ24 SCSI address?
Message-Id: <1993Jul3.135102.2322@cmkrnl.com>
From: jeh@cmkrnl.com
Date: 3 Jul 93 13:51:02 PDT
Organization: Kernel Mode Systems, San Diego, CA
Lines: 23
To: Info-VAX@kl.sri.com
X-Gateway-Source-Info: USENET

In article <930702102003.10887@DECUS.DECUS.DE>, KOST@DECUS.DECUS.DE writes:
>     Hello Nigel,
> 
>     near the powerconnector are three jumpers, you can set the SCSI ID by
>     set or remove the jumpers.

Near the power connector???  

I'm looking at an RZ24 that has just one jumper near the SCSI connector 
(near the "power connector end of the SCSI connector", to be more precise).

The SCSI address jumpers on this version are near a square chip labelled
"Conner 61006-001".  This is towards the front of the drive (the end 
opposite the SCSI connector).  They are labelled E3 through E1. E3 is the
MSB and E1 is the LSB, and "jumper in" turns the bit on.  

Hence SCSI ID 3 is jumpers E1 and E2 in.  

	--- Jamie Hanrahan, Kernel Mode Systems, San Diego CA
drivers, internals, networks, applications, and training for VMS and Windows NT
uucp 'g' protocol guru and release coordinator, VMSnet (DECUS uucp) W.G., and 
Chair, Programming and Internals Working Group, U.S. DECUS VMS Systems SIG 
Internet:  jeh@cmkrnl.com (JH645)  Uucp: uunet!cmkrnl!jeh  CIS: 74140,2055