From: Carl Perkins [carl@gergx.gerg.tamu.edu]
Sent: Tuesday, June 03, 2003 1:22 AM
To: Info-VAX@Mvb.Saic.Com
Subject: Re: Samba + Multinet: The Saga continues

brad@.gateway.2wire.net writes...
}In article <3ED8D0F8.E327BF86@fsi.net>, "David J. Dachtera" <djesys.nospam@fsi.net> writes:
}>Hoping that someone here can help...
}>
}>I'm still trying to get Samba V2.2-8 running with Mutlinet V4.2 Rev A
}>(maybe need newer?).
} 
}Possibly.  Check out the threads from this selection of samba-vms:
} 
}http://marc.theaimsgroup.com/?l=samba-vms&w=2&r=1&s=multinet&q=b
} 
}A number of posters seem to list MultiNet 4.4 as a minimum (I can't say for
}sure; I don't use MultiNet in my setup.

I'm still running Samba V2.2.7a, which works fine with Multinet 4.3A-X.

So keep in mind that I'm using a version of Samba that is 1 back from the
one you are tyring to get running, and my Multinet is 1 point version ahead
of yours, but 1 back from 4.4.

It is possible that V4.2 is too old, or you might check the patches - there
are a lot of them and the patch image replacements are often the same as
the images used in newer versions (so after the patching process you can
end up with varous parts of Multinet being the same executable that is
used in newer versions, including the current version).

}Also note this particular thread:
} 
}http://marc.theaimsgroup.com/?l=samba-vms&m=104266249319278&w=2
} 
}This poster lists the SMBD service in detail, as you do; note he has
} 
}Socket Options = SO_KEEPALIVE
} 
}as part of the service definitions; would this help?
}>Anyone have any ideas about where to look next?
}>
}>-- 
}>David J. Dachtera
}_________________________________________________________________
}Bradford J. Hamilton			"All opinions are my own"
}bMradAhamiPltSon@atMtAbi.cPoSm		"Lose the MAPS"

My SMBD service definition is the same as it has been for years, 
predating the V2 line of Samba, so it is not clear if some of it
is not needed. That said, I have the 

        Socket Options = SO_KEEPALIVE

set, and also have this:

        Flags = UCX_SERVER

in my SMBD service defintion. I also have a Max Servers setting, but that
should not be needed to get it working.

--- Carl